The Discovery 2, Radiator Muff / Wading Blanket has been designed to fit to the front grill with ease.

Features and Fitting:

Hard wearing and easy to clean PVC coated quality hooding fabric.

To install, simply lift the bonnet, and remove the 3 screws and rubber insert along the top edge that retains the grill into place as shown in the image blow and the 2 locating pegs on the underside of the grill will be released from the vehicle to enable you to fit (Posi drive screw driver required).

Attach the Cover at the bottom 1st with the J clip hooking over the lower lip.

Open up the flap a bit and this will make the cover easier to clip to the top lip as you have done underneath.

Ensure the cover is fitted correctly left to right, as it's easy to leave slack in the middle of the cover if not.

Attach the two short J clips on the ends to the left and right hand sides.

Now locate the grill back on the vehicle with the lower locating lugs in 1st and then line up the locating holes on top and insert the rubber lugs and screw back into place, close the bonnet and your done.

You can now roll up the centre flap and leave open.

Do not drive any distance with the centre flap closed. The cover is designed to be closed at night or when parked to protect the radiator from extreme weather or whilst off road to stop ingress of muck, water and mud into the radiator. Always make sure that it is not causing any problems with the temperature, using the gauge as a guide, though the product shouldn't effect this